User Guide
Table Of Contents
- About This Document
- Contents
- Introduction
- Getting Started
- Print Operations
- Determining Printer Configuration
- Long Term Printer In-activity or Storage
- Thermal Printing
- Modes of Printing
- Print Media Types
- Replacing Supplies
- Adjusting the Print Width
- Adjusting the Print Quality
- Media Sensing
- Ribbon Overview
- Printing on Fan-Fold Media
- Printing with Externally Mounted Roll Media
- Fonts and Your Printer
- Stand Alone Printing
- Sending Files to the Printer
- Print Meter
- EPL Line Mode
- Printer Options
- Maintenance
- Troubleshooting
- Appendix: Interface Wiring
- Appendix: Dimensions
- Appendix: ZPL Configuration
39
Print Operations
Printing on Fan-Fold Media
8/4/10 GK420t™ User Guide 980610-001 Rev. C
3.
Insert the media through the slot at the rear of the printer.
4.
Run the media between the media guide and roll holders.
5.
Close the top cover.
After printing or feeding several labels: If the media does not track down the center (moves
from side to side) or the sides of the media (liner, tag, paper, etc.) are frayed or damaged when
exiting the printer, then the media guides may need further adjustment. If this does not correct
the problem, then the media can be routed over the two roll holding pins on the media guide.
An empty roll core of the same width as the stack of the fan-fold media can be placed between
the roll holders to provide additional support for thin media.