User Guide
Table Of Contents
- About This Document
- Contents
- Introduction
- Getting Started
- Print Operations
- Determining Printer Configuration
- Long Term Printer In-activity or Storage
- Thermal Printing
- Modes of Printing
- Print Media Types
- Replacing Supplies
- Adjusting the Print Width
- Adjusting the Print Quality
- Media Sensing
- Ribbon Overview
- Printing on Fan-Fold Media
- Printing with Externally Mounted Roll Media
- Fonts and Your Printer
- Stand Alone Printing
- Sending Files to the Printer
- Print Meter
- EPL Line Mode
- Printer Options
- Maintenance
- Troubleshooting
- Appendix: Interface Wiring
- Appendix: Dimensions
- Appendix: ZPL Configuration
59
Maintenance
Cleaning
8/4/10 GK420t™ User Guide 980610-001 Rev. C
Sensor Cleaning
Dust can accumulate on the media sensors.
1.
Gently brush away dust; if necessary, use a dry swab to brush away dust. If adhesives or
other contaminates remain, use an alcohol moistened swab to break it up.
2.
Use a dry swab to remove any residue that may be left from the first cleaning.
3.
Repeat steps 1 and 2 as required until all residue and streaks are removed from the sensor.
.
Black-Line
Sensor
Ribbon Trailer
Sensor
Label Taken
Sensor
Gap
Sensor