User guide

Zebra GK420t User Guide COBISS System Management
4/18 © IZUM, 18. 3. 2013, VIF-NA-20-EN, V1.0
Serial connection
Figure 8: Serial connection
The printer comes with a serial and a USB interface. To connect the printer use the appropriate
cable.
During installation you can use the drivers available:
 on CD supplied with your printer,
 via http://www.zebra.com/id/zebra/na/en/index/products/printers/desktop/gk420t.4.tabs.html,
 via http://www.seagullscientific.com/downloads/drivers/archive/7.2/7.2/Zebra_7.2.exe,
To use the printer from several workstations, it is recommended to connect it only to one
workstation enabling shared use of the printer to other workstations. For help, call +386 (0)2
2520 333 (Call center) or send an email to [e-mail].
2.3 Cleaning the printhead
To clean the printhead, use the cleaning pen supplied with your printer containing the cleaning
solution. Use the cleaning pen tip to remove debris and dust that has built-up on the heater
element of the thermal printhead.
The cleaning pen can be used only once and make sure that you use it only for this purpose. If
you use it once again, the contaminants from previous uses may damage the printhead. Instead of
a cleaning pen, you can also use a soft cloth and pure alcohol.