User guide

Maintenance
Cleaning
68
P1032729-001 GT-Series™ User Guide 1/5/2011
5. Install the platen in the printer. Discard the cleaning swabs after use - do not reuse.
6. Make sure the bearings and drive gear are on the shaft of the platen.
7. Align the platen with the gear to the left and lower it into the printer’s bottom frame.
8. Gently rotate both platen bearing latch release tabs down toward the rear of the printer and
snap them into the notches in both bearing wells.
Allow the printer to dry for one minute before closing the dispenser door, media cover or
loading labels.
Other Printer Maintenance
There are no user level maintenance procedures beyond those detailed in this section. See the
Troubleshooting on page 75 for more information on diagnosing printer and print problems.
Notch in
Bearing Well