User guide

Maintenance
Replacing the Printhead
72
P1032729-001 GT-Series™ User Guide 1/5/2011
If needed, push the short arm’s pin into the left side of the ribbon frame and press the
printhead’s other release tab.
4. Use a Phillips screwdriver to remove the screw that holds the ground (green) wire.
Disconnect the two printhead cables from the printhead assembly by slowly and gently
pulling them straight out of the connector. Pulling the connector out at an angle may
damage the printhead’s connector pins and receptacle.
Ground Wire
and Screw
Printhead Cables and
Connectors