User Manual
Table Of Contents
- Contents
- About This Document
- Introduction
- Installation
- Getting Started
- Before You Begin
- Printing a Configuration Label — External ZebraNet 10/100 Print Server
- Printing a Network Configuration Label — Internal ZebraNet 10/100 Print Server and Wireless Print Servers
- Configuration of Wireless Securities
- View Wireless Status through the Control Panel
- Determining the Active Print Server
- Assigning an IP Address on any Print Server
- Setting and Monitoring Alerts on Any Print Server
- Checking Print Server Configuration Settings
- Enabling Protocols
- Defaulting ALL Print Servers
- Using WebView
- Using ZebraNet Bridge
- Using a ZPL Command
- Defaulting the ZebraNet 10/100 Print Server on the 105SL, S4M, PAX4, and External Devices
- Defaulting the Wireless Print Server on the S4M
- Defaulting the Print Servers on the ZM400 and ZM600 Printers
- Defaulting the Print Servers on the ZP Series, LP/TLP 2824 Plus, and G-Series Printers
- Defaulting the Print Servers on the HC100 Printers
- Defaulting the Print Servers on the 105SL, PAX4, Xi4, ZE500, and 105SLPlus Printers
- Defaulting the Print Servers on the ZD500R, ZT210, ZT220, ZT230, ZT410, and ZT420 Printers
- Defaulting the Print Servers on the ZD500R, ZT230, ZT410, and ZT420 Printers via the Control Panel
- Printing Queues
- Using Printing Protocols
- ZebraLink WebView
- Print Server Web Pages
- Control Panel
- Hardware Troubleshooting
- Troubleshooting the External 10/100 Print Server
- Troubleshooting the Internal ZebraNet 10/100 Print Server
- Troubleshooting the Wireless Print Server
- ZebraNet Bridge Discovery or Configuration Problems
- Unable to Print
- Unable to Configure Device
- HP JetAdmin or HP Web JetAdmin
- Wireless Error Messages
- General Wireless Issues
- Encryption and Authentication Issues
- IP Issues
- Frequently Asked Questions
- Glossary
- Index
Index
160
P1043301-005 11/21/13
O
onboard flash 107
output port configuration
print server configuration menu
119
overview
16
P
password
default
43
ping the printer
troubleshooting
140
poor signal strength
142
POP3 email printing
print server configuration menu
119
prerequisites
System V queue
83
primary network device
preference for active print server
58
primary/secondary settings
WebView
101
print
configuration label for an internal wired print
server
46
configuration label for external wired print server
44
print a configuration label for an internal wired print
server
minimum label widths
46
print a configuration label for external wired print
server
minimum label widths
44
print listing on label
WebView
96
print problems
troubleshooting
140
print protocol
86
FTP
87
print queue configuration
Berkeley Software Distribution (BSD)-Style
82
print server
reset
122
restore
123
status and configuration
112
to view port status
121
print server configuration menu
enabled protocols
115
output port configuration
119
POP3 email printing
119
SMTP email alert configuration
118
SNMP settings
117
TCP/IP configuration
116
TCP/IP logical printing ports
117
web admin settings
118
print server configuration settings
to check
68
print server features
WebView
112
print server status
to open configuration page
120
WebView
120
print servers
default to factory settings
75
printer configuration
to view settings
92
WebView
92
printer controls
view
110
WebView
110
printer memory
107
protocols
enable
72
enabled using WebView
72
print server configuration menu
115
Q
queue configuration
BSD-Style
82
System V
83
R
RADIO WARNING POOR SIGNAL message
142
requirements
browser support
16
wired print servers
22
wireless print servers
23
requirements for wired print servers
firmware
25
requirements for wireless print servers
firmware
27