Specifications

ZPL Commands
~NC
234
45541L-004 Rev. A ZPL II Programming Guide 9/15/06
~NC
Network Connect
Description The ~NC command is used to connect a particular printer to a network by
calling up the printer’s network ID number.
Format ~NC###
This table identifies the parameters for this format:
Comments Use this command at the beginning of any label format to specify which printer
on the network is going to be used. Once the printer is established, it continues to be used until
it is changed by another
~NC command. This command must be included in the label format to
wake up the printer.
The commands
^MW, ~NC, ^NI, ~NR, and ~NT are used only with RS-485 printer
communications.
Parameters Details
### = network ID
number assigned
(must be a three-
digit entry)
Accepted Values:
001 to 999
Default Value: 000 (none)