Specifications

ZPL Commands
^SQ
264
45541L-004 Rev. A ZPL II Programming Guide 9/15/06
^SQ
Halt ZebraNet Alert
Description The ^SQ command is used to stop the ZebraNet Alert option.
Format ^SQa,b,c
This table identifies the parameters for this format:
Parameters Details
a = condition type
Accepted Values:
A = paper out
B = ribbon out
C = printhead over-temp
D = printhead under-temp
E = head open
F = power supply over-temp
G = ribbon-in warning (Direct Thermal Mode)
H = rewind full
I = cut error
J = printer paused
K = PQ job completed
L = label ready
M = head element out
N = reserved
O = reserved
P = power on
Q = clean printhead
R = media low
S = ribbon low
T = replace head
U = battery low
V = RFID error (in RFID printers only)
W = all errors (in RFID printers only)
* = all errors (in non-RFID printers)