Specifications

Printer Overview
Printer Mounting
16
P1028247-001 Rev. B KR203 Hardware Integrator Guide 10/26/2010
Printer Mounting
The printer can only be mounted to the kiosk using the four printer mounting screw holes
shown in the illustration below. The printer is most secure when using all four of the
mounting positions connecting the printer’s base to a rigid metal base plate in the kiosk.
The kiosk’s metal printer mounting plate should be connected to the kiosks electrical
(earth) ground for purposes of controlling static discharge and electrical noise.
For information on ordering accessories, refer to "Contacts" on page 2.
Figure 3-7 • Printer Mounting
Table 3-3 • Mounting Configuration
Mounting Positions Kiosk’s Print Base Mounting Variation Details
1a and 1b
Full coverage of printer’s
base plate
• Minimum mount positions.
• Supports the Quick-Fit Hubs
• Supported by most Zebra
accessory mounting solutions.
1a and 2 Partial (and Full)
coverage of the printer’s
base plate
• Minimum three point mounting
to fight torsional forces.
1 (a and b) and 2
1b
2
1a