User`s manual

1 • 3 Printer Installation
The following will guide you through the installation of your P520i printer.
CAUTION: Limit AC power supplied to the P520i
Printer to 110 - 230 V AC, 60 - 50 Hz for an associa-
ted 1,40A - 0,80A. Limit excess current draw to 16
amps or less, using an associated circuit breaker or
other such device. Never operate the printer in a
location where operator, computer, or printer can
get wet. Personal injury could result. The
printer must be connected to an earthed electrical
power supply and properly protected against
electrical surges and grounding faults.
1 • Place the printer in a location that allows easy
access to all sides. The printer should never be
operated while resting on its side or upside down.
2 • Place the printer’s power switch in the OFF (O)
position.
3 • Insert the power cable to the printer power
socket and attach to grounded electrical socket of
the proper voltage and type.
CAUTION: Intermittent or unpredictable operation
may occur from unsecured connectors. If
damaged, the power cable must be replaced by an
exact equivalent.
Use only Parallel Cable under 3 Meters in length.
GETTING STARTED
4