User guide

Installation

Internal PSII

4/19/07 ZebraNet PrintServer II User Guide 45537L-004 Rev. A

6. On the back of the printer, use the flat blade screwdriver to remove the screws and the

cover plate.

This opens the mounting slot on the back of the printer.

7. Take the PSII and disconnect it as noted in this illustration:

8. As shown in this illustration, insert the short ends of each standoff into the holes on the

main logic board until you hear a click.

9. With the PSII device, take the cable and PSII board, go to the electronics side of the printer

and plug the parallel port socket of the

PSII board into the parallel port plug on the main

logic board.

Note • This illustration identifies the components you will be working with in the

upcoming steps.

Unplug this

connector from the

I/O board, so you

only have the cable

and PSII board.

I/O Board

Back

Cover

Parallel Port Socket

Cable

Cable Tie

PSII Board

Standoffs

Main Logic Board

Parallel Port Plug