User guide

11
Introduction
Getting Started
Using the
Printer
Troubleshooting
Accessories
Contact Us
QL Plus Series Quick Start Guide
Adjustable Shoulder Strap
Refer to figure above. Snap each end of the shoulder strap
into the “D” rings in the top of the printer. Hold the buckle
and adjust the strap as shown until you achieve the desired
length.
Kick Stand
Refer to the figure below. The Kickstand option allows users to use the
printer on a desktop. To use the optional Kickstand: Flip the Kickstand on
the back of the printer open until it locks in place. The printer will now sit at
an angle on a desktop.
Desk Stand
Refer to the figure opposite. To use the Desk
Stand: Slide the printer onto the Desk Stand as
shown. The printer’s belt clip will hook onto the
Desk Stand and retain it in place. Ensure that
the clip is securely attached to the Stand and
the media compartment of the printer is seat-
ed securely in the stand.
Holes are provided to secure the Desk
Stand to the work surface. The charger
anddataI/Ocablesmaybepluggedinto
the printer in the usual manner.
Do not charge the battery while
printing.
Hold Buckle
Pull Strap here to
lengthen
Pull Strap here
to shorten
Snap in to “D”
rings on printer
Rotate Kickstand until it locks
into position
Hook Belt Clip
over the Stand
Printer’s Media
Compartment sits in cutout