User Manual

Quick Reference Guide 5
Installation
Tabletop / Shelf Set Up
To set the Charger on a tabletop or shelf:
1. Place the Charger and the Power Supply Unit on a tabletop or shelf.
NOTE When required, use the screw inserts at the back and base to secure the
Charger to the tabletop or shelf surface (See Figure on page 4).
2. Connect the Power Supply Cable to the power connector on the back of the
Charger.
3. Use the Power Supply Cable Duct, on the back of the Charger, to route the
Power Supply Cable to the left or right side of the Charger.
4. Connect the AC plug of the AC Power Cord to a standard electrical outlet.
Wall Mount
WARNING! For safe mounting, it is essential to use wall anchors appropriate to
the wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood
studs whenever possible.
To mount the Charger on a wall:
1. Use the wall mount template drawing on page 17 to mark the screw location on
the wall.
AC Power
Cord
Power Supply
Cable
Power Supply Unit
100-240 VAC, 50-60 Hz Outlet
Power Supply Cable Duct
72-11589-01.book Page 5 Monday, October 19, 2009 9:22 AM