User Manual

6 SAC5070 8-Bay Battery Charger
2. Use four screws to mount the Charger to a wall. Ensure to use additional wall
mounting hardware, as needed, for safe mounting according to the wall type.
3. Connect the power supply cable to the power connector on the back of the
Charger (See Figure on page 5).
4. Use the Power Supply Cable Duct, on the back of the Charger, to route the
Power Supply Cable to the left or right side of the Charger.
5. Place the Power Supply Unit on a shelf or tabletop.
6. Connect the AC plug of the AC Power Cord to a standard electrical outlet.
220 mm (8.6 inches)
38 mm (1.5 inches)
10 mm
(0.39 inches)
5 mm
(0.19 inches)
NOTE: Use Wall mount template on page 17.
72-11589-01.book Page 6 Monday, October 19, 2009 9:22 AM