Quick Start Guide

ManualsBrandsZebra ManualsHardwareZD421c label printer - B/W - thermal transfer

Insert the ribbon cartridge. Press down until the cartridge clicks into place.

2 Remove Packing

3 Load Media (continued)

3 Load Media

5 Load Ribbon

1 Setup

4 Adjust Sensor

ZD421C

Desktop Printer

Quick Start Guide

6 Close Printer

Open the printer and remove the packing.Slide the release latches to the front to unlock the cover. Unroll and discard the outer layer of the media roll.

Spread the roll holders open and place the roll into the printer. Pull the end of the roll past the front edge of the printer.Verify the roll spins easily on the holder. Press the media under the guides.

Align the sensor to the center of the roll for regular labels. Align the sensor to the edge of the roll for marked labels. Press down on the front edge of the printer until it locks.

Scan the code to download and install Zebra Setup Utilities.

zebra.com/setup

Summary of content (2 pages)

PAGE 1
ZD421C 1 2 Setup 3 Remove Packing Load Media Desktop Printer zebra.com/setup Quick Start Guide 3 Slide the release latches to the front to unlock the cover. Open the printer and remove the packing. Pull the end of the roll past the front edge of the printer. Press the media under the guides. Unroll and discard the outer layer of the media roll. Load Media (continued) Spread the roll holders open and place the roll into the printer.
PAGE 2
7 8 Connect Power A. Plug the power supply into the printer. B. Plug the power cable into the power supply. C. Plug the power cord into an appropriate receptacle. D. The power supply lights green. 10 Smart Calibration 11 Press and hold the Pause and Cancel buttons for two seconds to line up the labels. Press and hold the Feed and Cancel buttons for two seconds to print a configuration report.