User Manual

Setup
171
2.
Load the non-Zebra ribbon roll onto the ribbon core adapter. Orient the adapter flange on the left side
and verify that the ribbon unwraps on the backside of the roll as shown in the illustration. Roughly
center the core over the adapters center line.
NOTE: The maximum roll width of 110 mm (4.3 in.) does not require centering. For media less than
maximum width down to the minimum width of 33mm (1.3 in.), use the graduated scale on the adapter
core to align the ribbon rolls to the media and printer.
Flange - Place on Left
Ribbon Exiting the Roll
in the Back