User's Manual

Maintenance
Cleaning
42
P1031442-001 ZP 450 User Guide 12/8/2010
Cleaning the Platen
The standard platen (drive roller) normally does not require cleaning. Paper and liner dust can
accumulate without effecting print operations. Contaminates on the platen roller can damage
the printhead or cause the media to slip when printing. Adhesive, dirt, general dust, oils and
other contaminates should be cleaned immediately off the platen.
Clean the platen (and media path) whenever the printer has significantly poorer performance,
print quality or media handling. The platen is the print surface and drive roller for your media.
If sticking or jamming continues even after cleaning, you must replace the platen.
The platen can be cleaned with a fiber-free swab (such as a Texpad swab) or a lint free, clean,
damp cloth very lightly moistened with medical grade alcohol (90% pure or better).
1. Open the media door, dispenser door, and remove the media.
2. Press the tabs on the right and left sides out. Then rotate them up.
3. Lift the platen out of the printer’s bottom frame.
4. Gently lean the platen with the alcohol moistened swab. Clean from the center out. Repeat
this process until the all of the roller surface has been cleaned. If there has been heavy
adhesive build-up or label jam, repeat with a new swab to remove residual contaminates.
Adhesives and oils, for example, may be thinned by the initial cleaning but not completely
removed.