User Manual
Table Of Contents
- Contents
- About This Document
- Printer Overview
- Using the Printer
- Preparing the Battery for Use
- Operator Controls
- Printer Status Icons
- Buttons
- Power Saving Features
- Verify That the Printer is Working
- Connecting the Printer
- Zebra Setup Utilities
- Wireless Communications with Bluetooth
- Bluetooth (BT) Security Modes
- WLAN Overview
- Setting Up the Software
- Designing Labels
- Near Field Communication (NFC)
- Wearing the Printer
- Preventive Maintenance
- Troubleshooting
- Specifications
- Miscellaneous
Using the Printer
27
3.
Pull the media supports apart as shown in Figure 19. When you move one support, both supports will
move.
4. Insert the roll of media between the supports in the orientation shown, and let the supports secure the
media in place. The media roll should be able to spin freely on the supports.
Figure 19 Loading Media
5. Close the media cover until it clicks into place and the media advances.
Figure 20 Closing the Media Cover
NOTE: Refer to the Zebra Programming Guide for information about adjusting the media feed length via a
Set/Get/Do (SGD) command.