User Manual

Using the Printer
30
Buttons
The user has the ability to use the three button interface on the printers with the following Power Up and
Run Time sequences.
Power Up Sequences
NOTE: A forced download is when the printer is powered up in a mode where it is running only the code
that allows for firmware downloads to happen.
Run Time Sequences without LED Flashes
LEDs
The printers feature a tri-colored LED ring located around the Power button which indicates the state of the
battery during charging process.
Sequence # Function Keys
1
Print configuration report Hold down Feed button while pressing the Power
button.
2 Print configuration report then
network report
Hold down Select button while pressing the Power
button.
3 Initiate forced download Hold down the Select and Feed buttons while
pressing the Power button.
4 Turn the printer on or off or to
enter Sleep Mode
Power Button
Sequence # Function Keys
1 Two-key and ZPL Config Hold down Feed button and Select button for 3
seconds.
2 Repeated Feed Events Feed button
3 Wake (if in Sleep Mode) Power button or Select button
Icon Behavior State of Battery
Power On/Charged Battery
Power On/Battery Eliminator Plugged In
Battery Charging (Amber LED Ring)
Sleep Mode and Charging (Blinking Amber LED Ring)
Sleep Mode (Blinking Green LED Ring)
Battery Fault (Red LED Ring)
(( ))
(( ))