User Manual
Table Of Contents
- Contents
- About This Document
- Printer Overview
- Using the Printer
- Preparing the Battery for Use
- Operator Controls
- Printer Status Icons
- Buttons
- Power Saving Features
- Verify That the Printer is Working
- Connecting the Printer
- Zebra Setup Utilities
- Wireless Communications with Bluetooth
- Bluetooth (BT) Security Modes
- WLAN Overview
- Setting Up the Software
- Designing Labels
- Near Field Communication (NFC)
- Wearing the Printer
- Preventive Maintenance
- Troubleshooting
- Specifications
- Miscellaneous
Using the Printer
45
Wearing the Printer
Swivel Belt Clip
The printers have a plastic swivel belt clip included as a standard feature. (It should be noted that printers
with extended capacity battery do not come equipped with a belt clip.) To use: hook the clip over your belt,
and ensure that the clip is securely attached to the belt. The belt clip will pivot to allow you to move freely
while wearing the printer. In order to install or remove the plastic Belt Clip, secure it to the cut-out in the
front of the printer (where shown).
Figure 34 Printer with Belt Clip
Hand Strap
The Hand Strap accessory attaches to the front posts of the printer to provide the user with a convenient
and secure method of carrying the printer. To attach the Hand Strap to the printer:
1. Attach one swivel snap hook to its corresponding post on the front of the printer.
2. Attach the opposite end of the strap to its corresponding post on the front of the printer where shown.
Figure 35 Hand Strap
Clip Here
Strap
Post
Swivel
Snap
Hook