User Manual
Table Of Contents
- Contents
- About This Document
- Printer Overview
- Using the Printer
- Preparing the Battery for Use
- Operator Controls
- Printer Status Icons
- Buttons
- Power Saving Features
- Verify That the Printer is Working
- Connecting the Printer
- Zebra Setup Utilities
- Wireless Communications with Bluetooth
- Bluetooth (BT) Security Modes
- WLAN Overview
- Setting Up the Software
- Designing Labels
- Near Field Communication (NFC)
- Wearing the Printer
- Preventive Maintenance
- Troubleshooting
- Specifications
- Miscellaneous
Troubleshooting
52
Troubleshooting Topics
No power
• Check that the battery is installed properly.
• Recharge or replace the battery as necessary.
• If using the battery eliminator to power the printer, ensure that it is connected properly to an active (ON)
source.
4 Bars 802.11 Signal Strength >75%
3 Bars 802.11 Signal Strength </=75%
2 Bars 802.11 Signal Strength </= 50% but >25%
1 Bar 802.11 Signal Strength </= 25%
0 Bars No network detected
On Bluetooth link established
Grayed Out Inactive
Blinking Data processing in progress
Steady No data being received
Blinking Out of media
Steady Media present
Blinking Media cover open
4 Bars >80% charged
3 Bars 60%-80% charged
2 Bars 40%-60% charged
1 Bar 20%-40% charged
0 Bars Low Battery
On Battery Eliminator present
(Replaces Battery icons)
On
(Media Out icon Off)
Printer in Segmentation Mode
On
(Media Out icon Off)
Printer in Draft Mode
Icon Status Indication
DC