Installation manual

Specifications
Specification
MINOTAUR
Continuous Output Power into 2 ohm 1300w x 1
Continuous Output Power into 4 ohm 750w x 1
Continuous Output Power 2 AMPLIFIERS bridged into 4 ohm 2600w x 1
Continuous Output Power 2 AMPLIFIERS bridged into 8 ohm 1500w x 1
Minimum Speaker Impedance 2 ohm
Minimum Speaker Impedance in Bridge Mode (2 amplifiers) 4 ohm
Power Response at any power into 4 ohms 10-60KHz -2dB
Frequency Response at rated power into 4 ohms 10Hz-30KHz -0.1dB
Input Voltage range for rated power into 4 ohms 0.35 to 8.6 volt
Input Impedance at 2KHz 47K ohm
Noise below rated output (30KHz limited) -103dB
Damping Factor at 20Hz with 4 ohms >80
Total Harmonic Distortion with 4 ohm 20Hz-20KHz
From 1 watt to rated power. Typically less than 0.05% <0.2%
Intermodulation Distortion <0.2%
Phase response at 20KHz Lagging 12 deg
Slew rate (volts per micro second)-In”Flat” mode 12
Low Pass Crossover (24dB/octave) 45Hz to230Hz
High Pass Crossover (48dB/octave) 10Hz to100Hz
Equalization (5 controls +/-12dB boost and cut) 25Hz, 31Hz, 40Hz, 50Hz, 63Hz with constant Q
Phase Control Variable from zero to -180 degrees
Line Outputs (Normal and Inverted phase) Yes
Protection - Short Circuit, DC, Thermal Yes
Power Source 10-14.5v DC Negative Ground
Current Consumption with Sine wave at 4 ohms 52A
Average current Consumption with Music at 4 ohms 11 to 15A
Idling Current <1.5A
Fuse rating with 4 ohm load 25A-35A depending on usage
Fuse rating with 2 ohm loadl **** 40A -60A depending on usage
Size W x H (247mmx55mm/9.7”x2.1”) x L 275mm/10.82” Excludes connectors
Shipping Weight (Kg/Lbs) 5.9/13
**** Under normal operating conditions the fuse rating for 4 ohm loads will suffice for 2 ohm loads. If the amplifier is driven for long periods of time into
2 ohm loads l the fuse rating may be increased as shown.
++
++
++
++
++ Driving amplifiers with continuous sine wave power is very stressful and is not indicative of an
amplifier’s real world performance. We actually prefer to use PINK NOISE as our test signal as it very
closely replicates typical music which is what our amplifiers were intended for in the first place. Our
amplifiers will double the 4 ohm power at 2 ohm when driven with pink noise
DO NOT OVER FUSE ANY AMPLIFIER.
Page 21
MINOTAUR