Installation manual

Specifications
Specification
DRACONIA
Continuous Output Power into 2 ohm 240w x 4
Continuous Output Power into 4 ohm 150w x 4
Continuous Output Power 2 channels bridged into 4 ohm 480w x 2
Continuous Output Power 2 channels bridged into 8 ohm 300w x 2
Minimum Speaker Impedance 2 ohm per channel
Minimum Speaker Impedance in Bridge Mode (2 channels) 4 ohm
Power Response at any power into 4 ohms 10-60KHz -2dB
Frequency Response at rated power into 4 ohms 10Hz-30KHz -0.1dB
Input Voltage range for rated power into 4 ohms 0.26 to 8.0 volt
Input Impedance at 2KHz 47K ohm
Noise below rated output (30KHz limited) -98dB
Channel separation at 2KHz >80dB
Damping Factor at 20Hz with 4 ohms >80
Total Harmonic Distortion with 4 ohm 20Hz-20KHz
From 1 watt to rated power. Typically less than 0.05% <0.2%
Intermodulation Distortion <0.2%
Phase response at 20KHz Lagging 12 deg
Slew rate (volts per micro second)-In”Flat” mode 12
Low Pass Crossovers (24dB/octave) 55Hz to 4KHz
High Pass Crossovers (24dB/octave) 55Hz-4KHz
Sub Sonic Filter (24dB/octave) 11Hz to 48Hz
Equalization (Zero to +12dB variable control with constant Q) Boost @40Hz with constant Q
Line Outputs No
Protection - Short Circuit, DC, Thermal Yes
Power Source 10-14.5v DC Negative Ground
Current Consumption with Sine wave at 4 ohms 42A
Average current Consumption with Music at 4 ohms 8 to 15A
Idling Current <1.5A
Fuse rating with 4 ohm load 25A-30A depending on usage
Fuse rating with 2 ohm load **** 30A -50A depending on usage
Size W x H (247mmx55mm/9.7”x2.1”) x L 275mm/10.82” Excludes connectors
Shipping Weight (Kg/Lbs) 5.9/13
**** Under normal operating conditions the fuse rating for 4 ohm loads will suffice for 2 ohm loads. If the amplifier is driven for long periods of time into
2 ohm loads l the fuse rating may be increased as shown.
++
++
++
++
++ Driving amplifiers with continuous sine wave power is very stressful and is not indicative of an
amplifier’s real world performance. We actually prefer to use PINK NOISE as our test signal as it very
closely replicates typical music which is what our amplifiers were intended for in the first place. Our
amplifiers will double the 4 ohm power at 2 ohm when driven with pink noise
DO NOT OVER FUSE ANY AMPLIFIER.
30
Page 22