Installation manual

Specifications
Specification
LEVIATHAN
Continuous Output Power into 2 ohm 330w x 6
Continuous Output Power into 4 ohm 190w x 6
Continuous Output Power into 6 ohm ++ 125w x 6
Continuous Output Power into 8 ohm 100w x 6
Typical Output Power into 4 ohm per channel (1% THD) 235w x 6
Continuous Output Power 3 pairs of channels bridged into 4 ohm 660w x 3 Channel pairs may be bridged independently
Continuous Output Power 2 channels bridged into 8 ohm 380w x 3 Channel pairs may be bridged independently
Minimum Speaker Impedance 2 ohm per channel ##
Minimum Speaker Impedance in Bridge Mode (2 channels) 4 ohm ##
Power Response at any power into 4 ohms 10-60KHz -2dB
Frequency Response at rated power into 4 ohms 10Hz-30KHz -0.1dB
Input Voltage range for rated power into 4 ohms 0.25 to 8.6 volt
Input Impedance at 2KHz 47K ohm
Noise below rated output (30KHz limited) -100dB
Channel separation at 2KHz >80dB
Damping Factor at 20Hz with 4 ohms >80
Total Harmonic Distortion with 4 ohm 20Hz-20KHz
From 1 watt to rated power. Typically less than 0.05% <0.2%
Intermodulation Distortion <0.2%
Phase response at 20KHz Lagging 12 deg
Slew rate (volts per micro second)-In”Flat” mode 12
High Pass Crossovers (24dB/octave) Channels 1+2 and 3+4 55Hz-4KHz
Low Pass Crossovers (24dB/octave) Channels 3+4 55Hz to 4KHz
High Pass Crossovers (24dB/octave) Channels 5+6 10Hz-105Hz May be used as a Sub Sonic Filter
Low Pass Crossovers (24dB/octave) Channels 5+6 40Hz to 235Hz
Protection - Short Circuit, DC, Thermal Yes
Power Source 10-14.5v DC Negative Ground
Current Consumption with Sinewave at 4 ohms 94A
Current Consumption with Music at 4 ohms 18 to 28A
Idling Current <1.5A
Fuse rating with 4 ohm load 30A-40A depending on usage
Fuse rating with 2 ohm load **** 40A -80A depending on usage
Size W x H (247mmx55mm/9.7”x2.1”) x L 410mm/16.14” Excludes connectors
Shipping Weight (Kg/Lbs) 5.9/13
**** Under normal operating conditions the fuse rating for 4 ohm loads will suffice for 2 ohm loads. If the amplifier is driven for long periods of time into
2 ohm loads l the fuse rating may be increased as shown.
## The amplifier has no issues driving 3 ohm bridged loads on channels 5+6 where channels 1-4 are run
In band or high pass mode
++
++
++
++
++
++
++ Driving amplifiers with continuous sine wave power is very stressful and is not indicative of an
amplifier’s real world performance. We actually prefer to use PINK NOISE as our test signal as it very
closely replicates typical music which is what our amplifiers were intended for in the first place. Our
amplifiers will double the 4 ohm power at 2 ohm when driven with pink noise
DO NOT OVER FUSE ANY AMPLIFIER.
Page 24