Installation manual

Page 25
Specifications
Specification
RA
Frequency Response 15Hz-240Hz Bandwidth Limited
Input Voltage range 0 to 2.25 volt (can be factory adjusted to any setting)t
Input Impedance from 15Hz to 240Hz 10K ohm
Output impedance Approximately 100 ohms
Output voltage Can drive a 600 ohm load at 9v RMS
Noise below 5 volt output (30KHz limited) -100dB
Total Harmonic Distortion 15Hz to 240Hz Less than 0.008%
Intermodulation Distortion Less than 0.01%
Low Pass Crossover (24dB/octave) 45Hz to 230Hz
Sub Harmonic Synthesizer Two bands, 32Hz and 45Hz
Level controls Sub harmonic Synthesizer 32Hz, 45Hz and Master
Compressor Attack Time 15msec
Compressor Release Time 1 second
Threshold Variable
System gain with no compression Maximum of 12.3dB
Volume control Variable from off to maximum
Power Source 10-14.5v DC Negative Ground
Current Consumption with Music at 4 ohms Less than 0.5A
Fuse rating Internal 3A
Size W x H x D Chassis mm 112.54 x 20 x 73
Size W x H x D Chassis inches 4.43 x 0.79 x 2.87
Size front panel W x H mm/inches 124.54/4.9 x 23.5/0.925
Shipping Weight (Kg/Lbs) 0.45/1.0
A NEW VERSION OF RA IS COMING SOON AND WILL HAVE ADDITIONAL
FEATURES. THESE ARE A VARIABLE PHASE SHIFT AND LOW
FREQUENCY SET OF CONTROLS.