Installation manual

Page 27
Four (4) MINOTAURS may be connected in a parallel-bridge configuration when the need
for ultra high power is required. Refer to the later diagrams.
Graphs showing the difference between conventional and constant Q equalizers
LOW IMPEDANCE LOADS - 1 Ohm and below - Our philosophy
There is no reason to run a “daily driver” or SQ system into these loads. The aim is quality
after all and not sound pressure.
We believe that the person who chooses to own one of our amplifiers has one interest
only and that is sound quality.
The amount of heat generated by an amplifier when driving 1 ohm or less is tremendous.
The gain is simply an ego trip. The loss is reliability and sound quality. Yes MINOTAUR
doubles its power from 4 to 2 ohm BUT this only represents a 3dB gain in power and in
our opinion is not audible.
We recognize that many will drive 2 ohm loads and MINOTAUR has been designed for
this. However we always urge our customers to choose their speaker impedance wisely
especially when using DVC drivers.
WE ARE ABSOLUTELY 100% AGAINST THESE LOADS