Installation manual

1+
1
2+
2
BRIDGE
3+
3
4+
4
BRIDGE
_
_
_
_
BATT+
REM
GND
MINIMUM LOAD IS 2 OHM/CHANNEL or 4 OHM/ BRIDGED PAIR
POWER CONNECTIONS
DESIGNED AND ASSEMBLED
IN THE USA by ZED AUDIO
DRACONIA/DREADNOUGHT Bridging instructions
Any pair of channels may be bridged independently of the others where the minimum load
impedance is 4 ohm per bridged pair.
For a pair of channels to be bridged it is required that the input signals of the channels be
the same.
To bridge channels 1+2 a Y-Adaptor is required and of course the signal should be mono.
However no harm can come to the amplifier if the signal content of the channels is not
identical.
Running channels 3+4 in “sub” mode (see page 43) automatically ensures that 3+4 have
the same signal as “sub” mode mono mixes the 3+4 input signals and send these to both
power amplifiers.
Below is shown the bridged connection for the four channels.
+
-
+
-
MINIMUM IMPEDANCE IS 4 OHM
PER BRIDGED PAIR
Page 47