Installation manual

11) Run channels 1+2 as high pass and channels 3,4,5 and 6 as low pass for a typical

front stage system.

12) Run channels 1+2 in high pass for the front stage, channels 3+4 in high pass for the

rear fill and channels 5+6 for the subs.

13) Run channels 1+2 in high pass for the front stage tweeters, channels 3+4 in band

pass for the front stage midrange and channels 5+6 for the subs.

14) A high power front stage system. Run Chs 1+2 as high pass in bridge (300w @ 8

ohm/600w @ 4 ohm), Chs 3+4 as high pass in bridge (300w @ 8 ohm/600w @ 4 ohm)

and channels 5+6 as low pass.

15) Run channels 5+6 in bandpass mode for 4 way systems where 5+6 run the lower

midrange drivers.

So as can be seen this amplifier can do quite a few things. For those of you who only

choose to use four of the six channels, just leave all connections free to the channels you

have chosen not use.

Some will ask why there are no switches to parallel the RCA input sockets. The answer is

quite simple.....there is no place to add these switches! So those of you who may use

Leviathan as a two channel tri-amplified system you will have to use Y-adaptors or if

you are bridging a pair of channels and need to feed both inputs with the same signal.

LEVIATHAN uses ultra fast MOSFETs in each channel rated at 50A. The power supply

incorporates the same 110A MOSFETs as are used in our other amplifiers except that 12

are used. The power supply in LEVIATHAN uses smart technology in the power supply

and this increases the efficiency of the amplifier. Isolated ground pre amplifier with

balanced drive is used.

The following diagrams show the many options available with LEVIATHAN. Referring to

the above 16 options we believe that the following diagrams will allow most installers to

configure LEVIATHAN correctly for each particular system.

Do NOT power up LEVIATHAN or any of our amplifiers with the

volume level high. The internal initializing circuits will “see” this as a fault condition and

shut the amplifier down. The ZED logo will flash on and off and the amplifier will have to

be powered down for >5 seconds and then reset. This has been done to protect all

components in the system, including YOUR ears!

Alternatively we can add the links before shipping and these links are easily removable.

Please refer to the diagram at the end of the LEVIATHAN diagrams. We can supply these

links on request or with your order.

Important note:

Leviathan

LEVIATHAN

Page 50