Installation manual

Page 67
Some suggested systems using various combinations of Zed amplifiers.
4 way using a MINOTAUR and a LEVIATHAN:
The LEVIATHAN is used for the lower mids (ch 5+6), upper mids (ch 3+4) and tweeters
(ch 1+2), MINOTAUR is used for the sub woofers.
4 way using DRACONIA and DREADNOUGHT:
The DRACONIA is used for tweeters (ch 1+2), midrange (ch 3+4), DREADNOUGHT runs
the lower mids (ch 1+2) and subs are handled by ch 3+4.
4 way using DRACONIA and DRACONIA or DREADNOUGHT and DREADNOUGHT:
As above but use the same amplifier type.
3 way using a MINOTAUR and either a DRACONIA or DREADNOUGHT:
MINOTUAR runs the subs, channels 3+4 of the four channel amplifier runs the mids and
the channels 1+2 the tweeters.
High powered 3 way using two LEVIATHANS:
Each LEVIATHAN is run with channels 1+2 and 3+4 bridged for the tweeters and
midrange (Yes over kill for the tweeters) and channels 5+6 bridged on each amplifier into
either an 8 or 4 ohm sub.
Front stage only system using either DRACONIA or DREADNOUGHT:
Channels 1+2 drive the front component speakers and channels 3+4 run the subs in
either two channel or bridged mode.
Medium or high powered multi sub woofer system using either DRACONIA,
DREADNOUGHT or LEVIATHAN:
Many of our customers want to run multiple subs where each sub is not necessarily the
same impedance or even make of driver.
LEVIATHAN - inputs to channels 5+6 only, set channels 1+2and 3+4 to “LP 5+6” on their
respective MODE switches. ALL 6 channels will then follow the settings of channels 5+6
but LEVEL controls are independent for each channel pair.
DRACONIA or DREADNOUGHT - Set the MODE switch on ch 1+2 to the “3+4” position
and set channels 3+4 to run in LP/BP on the slide MODE switch and to “SUB” on the push
MODE switch.
RA may be used as a line level interface before any amplifier (or channels of a
multichannel amplifier) which is being used for sub duty.