Installation manual

Page 72
New products scheduled for 2012 release
Owing to the bad economic climate we have decided to delay the launch of MEGALITH
and the tube hybrid amplifiers.
We are instead launching 5 new products which will fit below these products in this manual. They are less expensive but do
not lack features or power.
As of this time we have not decided on the names of the new amplifiers and so we have given them generic names.
* Balanced inputs accept line of OEM head unit signal levels with no adaptors
* High pass subsonic crossover 10Hz-50Hz
* Low pass 24dB/octave crossover 45Hz-240Hz Linkwitz
* Low frequency Eq at 40Hz variable 0 to +12dB
* Level control with a range of 350mV-8.7v
* Remote level control
* Auto turn on via signal sense, switches automatically if no 3-12v trigger voltage is sensed.
* Extremely small footprint of approximately 8”x5”x 1.5” high.
* Balanced inputs accept line of OEM head unit signal levels with no adaptors
* High or Low Pass crossovers on both pairs of channels 50Hz-3KHz at 12dB/octave Butterworth
* Level controls with a range of 320mV-7v
* Auto turn on via signal sense, switches automatically if no 3-12v trigger voltage is sensed.
* Extremely small footprint of approximately 8”x5”x 1.5” high.
* Balanced inputs accept line of OEM head unit signal levels with no adaptors
* High pass subsonic crossover 10Hz-50Hz at 24dB/octave Linkwitz
* Low pass 24dB/octave crossover 40Hz-235Hz Linkwitz
* Variable phase shift control
* Low frequency Eq at 40Hz variable 0 to +12dB with constant Q response
* Level control with a range of 250mV-8.2v
* Remote level control
* Auto turn on via signal sense, switches automatically if no 3-12v trigger voltage is sensed.
* Balanced inputs accept line of OEM head unit signal levels with no adaptors
* High and Low Pass crossovers on both pairs of channels 55Hz-4KHz at 12dB/octave Butterworth
* Flat, High Pass, Low Pass or Band Pass on both pairs of channels
* 2 or 4 input configuration
* Channels 3+4 have a low Eq control at 40Hz
* Channels 3+4 offer a sub mode with mono mixing
* Level controls with a range of 250mV-7.8v
* Auto turn on via signal sense, switches automatically if no 3-12v trigger voltage is sensed.
* Balanced inputs accept line of OEM head unit signal levels with no adaptors
* Channels 1+2 can run in Flat, High Pass, Low Pass or Band Pass mode 55Hz-4KHz
* Channels 3+4 can run in Flat, High Pass, Low Pass or Band Pass mode 55Hz-4KHz
* Channels 5+6 can run in Flat or Low Pass mode also with a high pass subsonic crossover
* Channels 5+6 feature a MONO mode with 40Hz low Eq variable 0 to +12dB
* Channels 5+6 feature a remote level control port - remote control is included
* 2 , 4or 6 input configuration
* Level controls with a range of 250mV-7.8v
* Auto turn on via signal sense, switches automatically if no 3-12v trigger voltage is sensed.
MIKRO 1 - A 200w 4 0hm mono block with these features:
MIKRO 4 - A four channel amplifier rated at 60w x 4
TRIDENT 1 - A 350w 4 ohm mono block with these features
TRIDENT 4 - A four channel amplifier rated at 100w x 4
TRIDENT 6 - A six channel amplifier rated at 70w x 6 or 70w x 4 + 250w x 1