User Manual

1. Keep the distance between the earbuds and mobile device within 32.8 feet.
2. De-activate the Bluetooth function on your mobile device.
3. Put the earbuds back to charging case before use. Take both earbuds out from
charing case and wait for 3 to 5 seconds for auto pairing. The earbud has indicator
blinking alternatively in Red and Blue. Another earbud will be blinking in Blue slowly
when auto pairing is done successfully.
4. Activate the Bluetooth function on your mobile device and select
“VERVE TWS” from the list shown.
5. After pairing is successful, both earbuds LED will be off.
*Attention: If the auto pairing is not successful, manual pairing between earbuds
is essential by following below procedures:
1. Make sure the earbuds are charged.
2. De-activate the Bluetooth function on your mobile device. (if you had been paired
the earbuds to some other mobile device(s) nearby, please sure to de-activate
those device(s) too).
3. Power on both earbuds simultaneously by pressing the On/Off buttons for
3 seconds and wait for 3 to 5 seconds for auto pairing. (Keep the Bluetooth
function off on your mobile device before this operation.)
4. Activate the Bluetooth function on your mobile device and select “VERVE TWS”
from the list shown.
5. After pairing successfully, both earbuds LED will be off.
1. Open the charging case cover.
2. Insert the Earbuds into the charging case.
3. The earbuds will start the charge automatically.
4. LED indicator light of the Earbuds will be turned to
Red when charging.
5. Once fully charged, the LED will be off.