Specifications

ZvBox 160 Get Going Guide Page 7 of 8
Configuration
Setting the channel via the Setup Button on the unit front
1.Wait for steady blue LED to indicate the
unit is ready for programming. Verify the
unit is unlocked. (Refer to “Unlocking
the Setup Button.”)
2.Digits are entered from left to right. Just
start entering them.
3. Each digit is entered by pressing the
button multiple times. A “zero” is
entered as 10 presses.
4.Wait for the LED to blink blue
between digits.
5. After all digits are entered, wait a few
seconds and the programmed channel
number is played back.
 The LED will blink red if an improper channel was selected. The original value
is restored.
  If the channel is valid, the broadcast is changed before playing back the new
channel.
To read back the current channel (assume it is 67)
Press and Hold the button until the LED turns yellow, and then blue again
- Release the button
The LED will ash yellow twice per second SIX times
There will be a two second pause
The LED will ash yellow twice per second SEVEN times
The LED will return to a steady blue.
Changing Modulation Standards:
Cable STD, HRC and IRC channel plan considerations: Most cable services program
their channel placements using a Standard (STD) channel lineup. In increasingly
rare cases, HRC or IRC channel placements are used. The modulator can be repro-
grammed to use these standards by entering the following channel numbers using
the channel programming procedure:
STD Channel 205
HRC Channel 206
IRC Channel 207
Example: Programming Channel 50
 Press the Button 5 times. The
LED blinks YELLOW at each press
Wait for the LED to ash BLUE
once
Press the Button 10 times
Wait for the LED to ash BLUE
once. Wait 5 more seconds (exits
channel setting mode)
The system will play back the
new channel number