User's Manual

Specifications
Drone power...............3.7V, 250
mAh lithium polymer battery
Remote Control
power..................4×AAA batteries
Control Distance........65 ft. (20m)
Specifications are subject to change
and improvement without notice.
Actual product may vary from the
images found in this document.
CHOKING HAZARD! Small
parts. Not for children under
3 years.
Lithium Battery Notes
• Followthemanufacturer’s
instructions for charging the
drone and do not charge longer
than recommended. Unplug the
charging cable when the drone is
charged.
• Donotpunctureorcrush.Donot
disassemble.
• Donotdisposeoflithiumbatter-
ies in the trash.
• Iftheelectrolyteinthecells
should get on your skin, thor-
oughly wash with soap and water.
Ifintheeyes,rinsethoroughly
withcoolwater.Immediatelyseek
medical attention.
• Donotattempttochargeor
operate damaged toys.
FCC Information
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
Part15oftheFCCRules.Theselimits
are designed to provide reasonable
protection against harmful interfer-
ence in a residential installation. This
equipment generates, uses, and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
Ifthisequipmentdoescauseharmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorientorrelocatethereceiving
antenna.
• Increasetheseparationbetween
the equipment and receiver.
• Connecttheequipmentinto
an outlet on a circuit different
from that to which the receiver is
connected.
• Consultyourdealer or an
experienced radio/TV technician
for help.
Ifyoucannoteliminatetheinterfer-
ence,theFCCrequiresthatyoustop
using your equipment. Changes or
modifications not expressly approved
by the party responsible for compli-
ancecouldvoidtheuser’sauthorityto
operate the equipment.
This device complies with Part 15 of
theFCCRules.Operationissubjectto
the following two conditions: (1) this
device may not cause harmful interfer-
ence, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
Limited Warranty
Go to www.radioshack.com/help for
details.
RadioShack Customer Relations
300RadioShackCircle,FortWorth,
TX 76102
www.radioshack.com
WehopeyouenjoyyourSurveyorCamera Drone from RadioShack.
Congratulations!NoFAARegistrationisrequiredforthisdrone.Pleaseread
thisuser’sguidebeforeusingyourdrone.
©2016 GeneralWirelessOperationsInc.Allrightsreserved.
RadioShackisaregisteredtrademarkusedunderlicensebyGeneralWirelessOperationsInc.dbaRadioShack.
06A16
6001433
Printed in China
Package Contents
• Surveyor Camera Drone  •USBChargingCable
• SparePropellers(4)  •2.4GHzRemoteControl
• User’sGuide   •3.7V,250mAhLithium-polymerbattery
Age 12+
SURVEYOR
CAMERA DRONE
Charge the Drone Battery
1. Use the USB charging cable to connect the battery to a USB
powersource.TheLEDontheUSBconnectorlightsredduring
charging, and turns off when charging is complete.
A full charge takes about 45 minutes, and provides up to 5
minutes of flight time.
2. After charging, unplug the charging cable. Do not attempt to
overcharge.
3. Openthedronebatterycompartmentdoortoconnectthebattery
socketcables.Thedrone’s4LEDsflash.Tuckthebatteryandwires
neatly inside the compartment and secure the door.
CAUTION:
• Use only the supplied lithium battery and cable, or ones with the
same specification to charge. Using any other batteries, cables or
different specifications may damage the drone.
• After playing, let thebattery cool before charging.
Battery Notes
• Disposeofoldbatteriespromptlyandproperly.Donotburnorburythem.Useonlyfreshbatteriesoftherequiredsizeand
recommended type.
• Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable
batteries of different capacities.
• Remove batteries during longer storage periods.
Install Batteries in the Remote Control
1. Turn off the controller.
2. Openthebatterycompartmentandinsert4×AAAbatteries(not
included), matching the polarity symbols (+ and –) marked inside
the compartment. Replace the battery cover securely with the
screws.
Note: Iftheremotecontrol’sLEDflashesduringuse,thebatteriesare
low and should be replaced.
3
LED
Camera Lens
Front LEDs (white)
Back LEDs (green)
Propeller (4)
6001433_UG_Eng.indd 1 6/21/2016 6:55:36 PM