User's Manual

Charge the Drone

1. Make sure the drone is turned o.

2. Connect the included USB charging cable to the drone's CHG jack and a

USB power source. The USB connector LED lights red during charging,

and turns o when charging is complete.

A full charge takes about 55-60 minutes, and provides up to 5 minutes

of ight time.

3. After charging, unplug the charging cable.

CAUTION

• Use only the included USB charging cable to charge the drone's battery.

Other cables may damage the drone.

• Always let the drone battery cool before recharging.

Lithium Battery Notes

Your drone uses a built-in lithium polymer battery for power. Follow the

instructions for charging.

• Do not charge longer than recommended. Unplug the charging cable when

the drone is charged.

• Do not puncture or crush. Do not disassemble.

• Do not dispose of lithium batteries in the trash.

• If the electrolyte in the cells should get on your skin, thoroughly wash with

soap and water. If in the eyes, rinse thoroughly with cool water. Immediately

seek medical attention.

• Do not attempt to charge or operate damaged toys.

Install Batteries in the Remote Control

1. Make sure the remote control is turned o.

2. Use a screwdriver to open the twin battery compartments. Then insert

four AAA batteries (not included), matching the polarities (+ and –)

marked inside. Replace the cover.

CHG

ON/ OFF

LED

6001432_PM_En.indd 4 6/21/2016 12:04:21 PM