TABLE OF CONTENTS Warnings and Cautions . FCC Information . Location of Parts and Controls ce Operation Replacing The Propeller B Blades Troubleshooting . . Care and Maintenance Stunt Drone Specifications... Warranty...
CAUTION + TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. THERE ARE NO SERVICEABLE PARTS INSIDE. + TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. The lightning flash with arrow-head symbol within an equilateral triangle is intended to alert the user 10 the presence of insulated “dangerous voltage” within the unit's enclosure that may be of sufficient magnitude fo constitute a risk of electric shock.
STUNT DRONE WARNING: The Stunt Drone is designed for INDOOR or OUTDOOR flight. The Stunt Drone's blades revolve at high speeds and can cause damage to the user, spectators and animals. Stand away from the Stunt Drone to reduce the risk of getting inch the flight path. Wam spectators that you will be fining your Stunt Drone so that they are aware of its position. Before flight, inspect the rotor blades to make certain that the blades are securely fastened to the Stunt Drone.
WARNING! + Choking/Cutting Hazard. Small Parts/Sharp Rotor Blades, + Keep hands, hair and loads clothing away from the propeller when the power switch is turned to the ON position. + Disconnect the controller and Stunt Drone power switches when not in use. « The included charger is built specifically for the Stunt Drone Li-Poly battery. Do not use it to charge any other hatter. + Parental supervision recommended when flying the Stunt Drone. /N\ WARNING! CHOKING HAZARD Small pars | Not stable for chicken und
BATTERY WARNINGS RECHARGEABLE BATTERY (STUNT DRONE): This device contains a removable Lithium-Polymer battery. The battery must be recycled or disposed of proper. Contact your local waste management office for information on battery recycling or disposal, CONTROLLER BATTERIES {NOT INCLUDED): + Do not mix old and new batteries. » Non-rechargeable batteries are not to be recharged + Rechargeable batteries are to be removed from the item before being charged (if removable).
+ Exhausted batteries should be removed immediately and must be recycled or disposed of properly according to state or local government ordinances and regulations. + The supply terminals are not to be short-circuited. + Only batteries of the same or equivalent type as recommended are to be used. + Batteries are to be inserted with the correct polarity. « Do not dispose batteries in a fire batteries may leak or explode: DANGER To reduce the risk of electric shack, bums, fire or injury: 1.
WARNING 1. 2. Close supervision is necessary when this appliance/product is used by or near children or mentally disabled individuals. Use this unit only for its intended use as described in this manual. Unplug this unit during lightning storms or when unused for long periods of time. Never drop or insert an object into any opening. . Protect the power cord from being walked on of pinched, particularly at plug outlets, convenience receptacles and the point where it exits the unit .
. Do not overload the electrical outlet Use only the power source as indicated. 10. Do not carry this unit by its cord or use the cord as a handle. 11. Never operate this unit if it has a damaged cord or plug, if it is nat working properly, or if it has been dropped or damaged, or dropped info water. If the unit's power supply cord or plug is damaged, do not attempt to fix it yourself. 12. To avoid the risk of electric shock, do not disassemble or attempt to repair the unit.
FCC INFORMATION Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules.
+ Connect the equipment to an outlet on a circuit different from that fo which the receiver is connected. + Consult the dealer or an experienced radio/TV technician for help. This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This equipment may not cause harmful interference. 2. This equipment must accept any interference received, including interference that may cause undesired operation.
LOCATION OF PARTS AND CONTROLS 7 1. Blade 5. Marat 2. Upper Sahel LED Indicator 9. Bottom Shell 7. Guard Frame.
LOCATION OF PARTS AND CONTROLS 1. Fight Mode 6 Flip 180° 2 Fiona Tune Forward Revs 8 ON OFF B/M 7. HOLLOW Speed LED 4.
INSTALL BATTERIES IN THE TRANSMITTER 1. On the transmitter set the on/off switch to off. 2. Use a screwdriver to open the battery compartment 3. Insert four AAA batteries (not included), matching the polarities marked inside. Use alkaline batteries for optimal performance. During play, if the transmitter's LED flashes, replace the batteries. CHARGE THE DRONE BATTERY Use Li-Polymer battery for power 1. Tum drone switch to off, and connect to USB cable. 2.
CALIBRATING THE DRONE 1. After pairing, move the throttle backward and the steering forward at the same time. Hold this until the drone's two LED flash about three seconds. 2. When LED stop flashing, the calibration is complete. After calibration, the drone should fly smoothly and hover in the air, if not, rim your drone to fine-tune.
GET READY TO FLY 1. Open the battery cover at rear of the drone, plug the battery. The drone's head red LED flashes. 2. Place the drone on the level ground. 3. Set the transmitter switch to ON. Transmitter LED flashes and beeps. 4. Move the throttle all the way from descent. And back to middle position to pair the drone and transmitter. If pairing is successful, the transmitter sounds. The drone's and the transmitter LED indicator will stop lashing and lights will stay on. Note: If pairing failed.
FLY YOUR DRONE 1. Once paired. Press down the steering control(right joystick) to switch between high speed(double beep) and normal spreadeagled beep). 2. For beginners, use normal speed or beginner to fly. In beginner mode, ascent and descent will be slow. Operators can move up and down while flying the drone slowly. Avoid moving the throttle toa quickly to prevent faking 3. For advanced users, use high speed mode or Expert made(ON) to fly. 4.
FLIGHT MODE In this mode, there is no difference between the head and tail. Press "FLIGHT MODE” button so that the drone’s head and tail direction will not matter. It is subject to the original orientation to become the drone's forward direction.
FLIP STUNTS 1. Press the 180° button: the transmitter beeps: 2. Move steering control to perform fp. «Front flip: move lever forward «Back flip: move lever backward «Left/right flip: nave lever left/right 3. To exit stunt mode without a fip, press the flip button again before moving the steering control. Make sure there is enough space for the drone to perform a flip. TRIM YOUR DRONE Push the throttle forward and observe how the drone reacts.
REPLACING THE PROPELLER BLADES The Stunt Drone's propeller system is a precision instrument that may need repair or replacement for optimal fight function. Crash landing from high-speed aerial fights may causal damage to your Stunt Drone's propellers. 1. Before making any repairs, fur off the power and disconnect the battery. 2.
+ Make sure the drone is within the control range (120 ft/36.5 m) and in line of sight, Drone difficult to control + The throttle control is very sensitive. Use small, fine movements to control. + Practice B/M (Easy) mode. « Propellers maybe deformed or damaged. Adjust propellers by hand. If you cannot adjust them, replace with the spare propellers. Drone swerves or moves thematically before taking off « The gyroscope inside your drone needs calibrating: 1.
CARE AND MAINTENANCE + Always remove the batteries from the controller when it will not be used for an extended period of time. «To clean, gently wipe the drone and controller with a clean damp cloth. + Parental guidance recommended when installing or replacing the batteries. STUNT DRONE SPECIFICATIONS Li-Poly Rechargeable Battery: 3.
ONE(1) YEAR LIMITED WARRANTY Brookatons® warrant this proctor against defects in malarial and/or workmanship under normal use for a period of ONE (1) YEAR from the date of purchase by the original purchaser ("Warranty Period’).
other than Brooks tone may provide their own warranties to the purchaser, but Breastbone, in #5 far ea partitioned by law, provides theses products "sa is” This warranty does not apply to: a) damage caused by failure to follow instructions relating to product's use or the installation of components; b) damage caused by accident, abuse, misuse, firs, floods, earthquake or other textual causes; o damage caused by service proforma by anyone who ia not a representative of Brooks tone; d} accessories used in con