User's Manual

14 15
Use the Detachable Camera
The red LED inside the camera ashes when connected to the drone
and the drone is turned on.
1. Insert a Micro SD card (not included) into the card slot. Push the
SD card in until it clicks.
2. When the drone ies stably,
• Press once to take a photo. The remote control beeps
and the drone's back LEDs ash once.
• Or, press to record a video. The remote control beeps
and the drone's back LEDs ash on. Press again to stop
recording.
3. To remove the SD card, press it to eject it.
Note: The video recorded may fail to play in some video applications
if (1) the SD card falls out due to a crash, and (2) you remove the SD
card or drone battery during video recording.
Replace Damaged Blades
The left and right blades of the drone are dierent (see R/L
orientation marking on underside); you must use the correct blade
in the correct location. If you need additional blades, visit your local
RadioShack store for help.
To replace a damaged blade, remove the old one and press the new
one onto the blade axle. If you cannot remove the old blade by hand,
use pliers.
WARNING:
• To avoid injury and damage, inspect the blades for nicks and
breaks and make sure they are securely attached before and after
each ight. Replace nicked, chipped, cracked or broken blades.
• Use only the supplied blades. Do not alter, modify, or customize
the blades.
Troubleshooting
Drone does not respond
• Make sure the drone and remote control are switched on and
paired. When paired, the LEDs of the drone and remote control
light steadily.
• The drone battery may be low. Fully charge the battery. See
“Charge the Drone Battery.“
• Remote control battery may be low. Replace the batteries.
• Make sure the drone is within the control range (200 ft./60.96m)
and in line of sight.
Drone difficult to control
• The blades may be deformed due to a crash. Adjust deformed blades
by hand. If you cannot adjust them, replace with the spare blades.
• The throttle control is very sensitive. Use small, ne movements
to control.
• If you are a beginner, set to low speed mode or use Special mode.
See “Fly Your Drone.“
Video Photo
Camera
Connector
Micro USB port
Use a Micro USB cable (not included) to connect your
computer for video/picture les download; or to power
the camera independently.
6001352_UG_EN_030315.indd 14-15 3/3/2015 2:52:41 PM