User's Manual

4 5
Install Batteries in the Remote Control
1. Ontheremotecontrol,setthe ON/OFF switch to OFF.
2. Use a screwdriver to open the twin battery compartments. Then
insertfourAAbatteries(notincluded),matchingthepolarities(+
and –)markedinside.Replacethecover.
Note:Iftheremotecontrol’sLEDashesduringuse,thebatteries
are low and should be replaced.
Battery Notes
• Dispose of old batteries promptly and properly. Do not burn or bury them.
Use only fresh batteries of the required size and recommended type.
• Donotmixoldandnewbatteries,dierenttypesofbatteries(standard,
alkaline,orrechargeable),orrechargeablebatteriesofdierentcapacities.
• Remove batteries during longer storage periods. Batteries can leak
chemicals that can damage electronic parts.
Lithium Battery Notes
• Follow the instructions for charging. Do not charge longer than
recommended. Unplug the charging cable when the drone is charged.
• Do not puncture or crush. Do not disassemble.
• Do not dispose of lithium batteries in the trash.
• Iftheelectrolyteinthecellsshouldgetonyourskin,thoroughlywash
withsoapandwater.Ifintheeyes,rinsethoroughlywithcoolwater.
Immediately seek medical attention.
• Do not attempt to charge or operate damaged toys.
Charge the Drone
Your drone uses a built-in lithium polymer battery for power.
1. Set the drone's ON/OFF switch to OFF.
2. ConnecttheincludedUSBchargingcableto the drone's CHG
jack andaUSBpowersource(suchasalaptop).TheLEDinside
theUSBconnectorlightsredduringcharging,andturnsowhen
charging is complete.
A full charge takes about 55 minutes,andgivesupto7 minutes
ofighttime.
3. Aftercharging,unplugthechargingcable.
CAUTION
• Use only the included USB charging cable to charge the drone's
battery. Other cables may damage the drone.
• Always let the drone battery cool before recharging.
CHG
ON/OFF