User's Manual

8 9
Get Ready to Fly: Pairing
1. Turnonthedrone.Thedrone'sLEDsash.
3. Place the drone on level ground.
4. Turnontheremotecontrol.Theremotecontrol'sLEDashes.
5. Move the throttle all the way up and then down to pair the
remote control with the drone. The drone’s blades remain still
duringpairing.Whenpaired,theLEDsonboththeremote
control and drone light steadily.
Note: Ifpairingfails,turnothedroneandremotecontrolandrepeat
thestepsabove,orchangelocationstoavoidelectricalinterference.
Fly Your Drone
1. Afterpairing,pushthesteeringcontrolintoswitchbetweenhigh
speed(doublebeep)andlowspeed(singlebeep).
2. Withthedroneontheground,movethethrottleforwardto
ascend.Toavoidgroundairturbulence,ythedroneatleast1ft.
(300cm)otheground.
For advanced users:Holdtheremotecontrolwithonehand,
resting your thumb on the throttle. Throw the drone about 9 ft.
(3m)awayfromyou,andmovethethrottleforwardtoy.The
droneadjustsitselfautomaticallyandiessmoothly.
IMPORTANT: Ifyourdronecrashesupsidedown,pullthethrottle
all the way down. Wait till the blades have stopped still before you
handle the drone.
Trim Your Drone
Move the throttle forward and see how the drone reacts.
Forward/Reverse Movement Trim: If the drone tends
tomoveforward,press
f
;ifittendstomovebackward,
press
g
.
Left/Right Slide Trim:Ifthedronetendstoslideright,
press
f
;ifittendstoslideleft,press
g
.
Note: Theremotecontrolbeepswhenyoupressatrimcontrol,but
stops beeping when you reach maximum trim adjustment.
Land Your Drone
1. Slowly move the throttle backward to descend. Avoid moving
thethrottletooquickly,asitcanstopthebladesinstantlyand
cause the drone to crash.
2. Whenyounishplaying,turnotheremotecontrolanddrone.
Perform Stunts
CAUTION: Make sure there is enough space for the drone to
perform stunts without crashing into objects or people.
1. Push the throttle control to activate stunt mode. The remote
control beeps repeatedly.
2. Use the steering control to perform stunts:
• Front ip: Move steering forward
• Back ip: Move steering backward
• Barrel roll: Move steering right or left
3. The drone automatically exits stunt mode after performing a
stunt,orpushinthethrottlecontrolagaintoexitimmediately.
Calibrate the Drone
Ifcontrollingthedronebecomesdicult,trythefollowing:
1. Select an open location free from strong magnetic interference.
Place the drone on level ground.
2. Turnonthedroneandtheremotecontrol,andpair.
3. Withthethrottleallthewaydown,movethesteeringcontrolall
thewayupuntilthedrone'sLEDsashrapidly.
4. Whenthedrone'sLEDslightsteadily,yourdroneiscalibrated
andshouldysmoothly.