User`s manual

- 16 -
Recalculate All Positions : When all the locations of searched satellites are shifted for any reason,
you can realign all of them once you adjusted one satellite location.
Goto Reference: When you install the motor of DiSEqC 1.2 antenna, you can select this function
to move the center of the antenna to 0°.
Limit Setting: East West Limit
On selecting Limit Setting, the Limit Setup
menu will pop up. Pressing the Left key on the
RCU continuously will take you to the eastern
most point. Press the OK key on the RCU. The
message “Would you like to set East limit of
DiSEqC motor?” will be displayed for your
confirmation. Place cursor on the OK button on
the screen and press OK key on the RCU to
confirm the East limit.
To set West limit, follow the same steps as East
limit.
Reset Limit
Place the cursor on Reset Limit button and then press OK key on the RCU. The message “Would
you like to reset limit for DiSEqC positioner?” will be displayed for your confirmation. Select OK
button by pressing OK key on the RCU.
4.5 Factory Default:
If you want to bring DSR back to the factory
default condition, select factory default and
press OK button. Than a warning message will
displayed. To confirm, select YES.
Warning: On selecting factory default you will
lose all of data and information, which was
previously installed.
5. Preferences
This menu consists of 7 sub-menus as shown
below:
1. System Options
2. AV Setting
3. Video Adjust
4. Time Setting
5. Parental Control
6. Software Update
7. About Receiver