User`s manual

- 32 -
12. Easy plug-and-play data transfer without PC
Below you can find another easy method to upgrade operating software by
easy plug-and-play data transfer from one receiver to the other.
1. Notice that both receivers, master and slave, are powered off .
2. Connect one
receiver
to another
receiver
by using RS 232 cable.
3.
Switch your master receiver to stand-by mode.
4.
Turn on the slave receiver by Power ON/OFF and check the front
display is "d.000". From now on the slave receiver will be upgraded.
5.
During the download the
receiver
front display will show the progress
of the procedure, e.g. "d.062" means 62% data transfer finished.
6.
A
fter completed d ownload,
the receiver
automatically writes
downloaded data in its Flash Rom. Please wait until it displays
“good”
message on the Front Panel Display.
Receiver
has to be re-booted
by power off/on if the procedure is completed.