User`s manual

- 7 -
• Solar radiation/heat
Do not place the receiver close to radiators nor expose it to direct sunlight.
• Grounding
The parabolic antenna is to be grounded in accordance with regulations. Here, the
relevant German VDE regulations (or equivalent) are to be observed.
Connecting up and putting into operation
• Attention
The following section is intended specifically for the specialist dealer. If you are not carrying
out the installation yourself, there is no need to pay any attention to this section. A sample
configuration is to be found in section: "Connection examples".
Do not connect the unit to the mains until after the installation work has been carried out
properly.
Please note the guidance given in section: “Safety- and Installation instructions”.
1.3 Unpacking
Unpack the DX 2202 and check to make sure that all of the following items are included in the
packaging.
• 1 x Remote Control Unit (RCU)
• 1 x User’s Guide
• 2 x AAA batteries
• 1 x DX 2202
1.4 General Operation of the DX 2202
Throughout this manual you will notice that the everyday operation of your DX 2202 is based on a
series of user friendly on screen display and menus. These menus will help you get the most from
your DX 2202, guiding you through installation, channel organizing, viewing and many other
functions.
All functions can be carried out using the buttons on the RCU, and some of the functions can also
be carried out using the buttons on the front panel.
Please be aware that new software may change the functionality of the DX 2202.
Should you experience any difficulties with the operation of your DX 2202, please consult the
relevant section of this manual, including the Problem Shooting.
Hotline
 in Germany, in case of questions !
Daily between 8.00 – 16.00 h
Phone: [phone] (25 Cent per Min.) e-mail: [e-mail]