Specifications

Start-Up
Carl Zeiss Unpacking, Attaching ergonomic base plate Axiostar plus
2-4 B 40-815 e 12/01
1 Plastic feet
2 Base pod
Fig. 2-1 Inserting base pods
2.2.1 Attaching the ergonomic base plate
• Remove the tube if one is attached.
• Tilt the stand back and set it down.
• Remove the four plastic feet (Fig. 2-1/1)
from the stand and replace with the four
base pods included (Fig. 2-1/2). If necessary,
clean adhesive or varnish remains from the
drilled holes.
• Turn over the stand and place it top side
down on a soft surface or the packing
cardboard (Fig. 2-2).
• Secure the microscope in this position or
have a second person hold it to avoid
damaging the microscope.
• Place the ergonomic base plate (Fig. 2-2/1)
on the bottom of the stand and fasten with
the four Allen screws (SW 2.5 M4 x 30
(Fig. 2-2/2) using the four washers.
• Turn the microscope over and set it down
on the ergonomic base plate.
• Reattach tube and secure.