Technical data

G-30-1346-en S8 Floor Stand Issue 4.0
Printed on 05. 06. 2001
Operation 101
OPMI
®
VISU 150 / 200: assigning a function to keys C and D of the
foot control panel
The two keys C und D of the foot control panel are freely configurable.
In configuration mode 1, you can use the upper and middle sections of the
display and key field to assign any of the following functions to keys C and
D:
For a detailed description of the functions, see below.
FOOT LEFT C:
Use the upper section of the display and key field (FOOT LEFT C:) to as-
sign one of the possible functions to key C of the foot control panel.
FOOT RIGHT D:
Use the middle section of the display and key field (FOOT RIGHT D:) to
assign one of the possible functions to key D of the foot control panel.
Rollover
Select the function required using a rollover run in the sequence defined
in the above table.
At each press of the "∇" key, you advance in clockwise direction. At each
press of the "∆" key, you advance in counterclockwise direction:
→ XYZ-RES → FOC-MEM → XY-INV →
↑↓
← XY-RES ← AUX ← PHOTO ← SDI ←
Display Function of key C or D of the foot control panel
XY-RES Recenters XY ("RESET") and resets focus
XYZ-RES Recenters XY, resets focus and zoom
FOC-
MEM
Focus memory Key pressed < 2 s:
Key pressed > 2 s:
triggers positioning
saves the position
XY-INV Inverts the X-Y coupling movement using the foot control
panel
SDI Inverts the SDI movement
PHOTO Triggers an exposure at the photo interface
AUX Triggers an AUX signal at the AUX interface
Path: After you have switched on the instrument, the basic mode is auto-
matically displayed.
To access configuration mode 1 from the basic mode, simultane-
ously press the "MODE" and "STORE" keys.
C
D
Configuration
mode 1
MODE
STORE MANUAL
FOOT
LEFT C:
PHOTO
FOOT
RIGHT D:
PHOTO
SPEED
FUNCT:
HIGH