Technical data

54 Preparations for use
G-30-1346-en S8 Floor Stand Issue 4.0
Printed on 05. 06. 2001
• Screw in the securing screw (7) and tighten it firmly . The securing
screw (7) must go into the groove (9). This is ensured when the secu-
ring screw is flush with the outer surface of the coupling.
• Hook the coupling (12) including the surgical microscope from above
into the receptacle (11) on the suspension arm and tilt the coupling
downward into its vertical position.
• Firmly tighten the mounting screw (3) using a 5 mm Allen key.
• Plug the cable clip (10) into the opening (13) of the coupling.
• Then perform the balance setting procedure.
Warning!
Before using and after re-equipping the unit, always make sure that se-
curing screws (3), (4) and (7) have been tightened firmly.
Note:
When mounting surgical microscopes with an integrated coupling, steps
3 to 9 need not be performed.