Technical data

G-30-1346-en S8 Floor Stand Issue 4.0
Printed on 05. 06. 2001
Operation 79
OPMI
®
Vario: display of working distance or total magnification;
switchover of display
This control function permits you to toggle between the two displays.
In the basic mode, the middle section of the display shows either the wor-
king distance (in mm) or total magnification (as a factor).
Use the "∇" and "∆" keys to toggle between the two displays.
Working distance
The working distance is displayed in the form of a symbol and a numerical
value indicating the current working distance in millimeters. The current
working distance is displayed in steps of 5 mm.
Total magnification (MAG)
The total magnification of the optical system is displayed with the abbre-
viation "MAG" and a numerical value (factor) indicating the current total
magnification in steps of 0.1.
The total magnification is computed by the software. The magnification
data of the eyepieces currently used must be known to the software for
this purpose. Enter the current eyepiece magnification in configuration
mode 3.
Saving parameter settings
As soon as you have entered a parameter setting, it is saved under the
current user ID.
Caution:
Be extremely careful when changing these settings. You should change
settings only under your own user ID. Notify all users of any changes, or
make sure that each user only works under his own user ID.
Path: The basic mode is automatically displayed after the instrument has
been switched on.
MODE
STORE MANUAL
USER
1
250 mm
1
5.0
Basic mode
MODE
STORE MANUAL
USER
1
10.9
1
1.5
MAG
Basic mode