Technical data

82 Operation
G-30-1346-en S8 Floor Stand Issue 4.0
Printed on 05. 06. 2001
OPMI
®
Vario: assigning a function to keys C and D of the foot control
panel
The two keys C and D of the foot control panel are freely configurable.
In configuration mode 1, you can assign any of the following functions to
keys C and D using the upper and middle sections of the display and key
field:
FOOT LEFT C:
Use the upper section of the display and key field (FOOT LEFT C:) to as-
sign one of the possible functions to key C of the foot control panel.
FOOT RIGHT D:
Use the middle section of the display and key field (FOOT RIGHT D:) to
assign one of the possible functions to key D of the foot control panel.
Rollover
Select the function required using a rollover run in the sequence defined
in the above table.
At each press of the "∇" key, you advance in clockwise direction. At each
press of the "∆" key, you advance in counterclockwise direction:
→ FOC-MEM → ZOOM-MEM →
↑↓
← XY-RES ← AUX ← PHOTO ←
Display Function of key C or D of the foot control panel
XY-RES XY recentering ("RESET")
FOC-
MEM
Focus memory Key pressed < 2 s:
Key pressed > 2 s:
triggers positioning
saves the position
ZOOM-
MEM
Zoom memory Key pressed < 2 s:
Key pressed > 2 s:
triggers positioning
saves the position
PHOTO Triggers an exposure at the photo interface, i.e. releases the
shutter of a 35 mm camera, if connected.
AUX Triggers an AUX signal at the AUX interface, e.g. for
switching an external unit on or off.
Path: After you have switched on the instrument, the basic mode is auto-
matically displayed.
To access configuration mode 1 from the basic mode, simultane-
ously press the "MODE" and "STORE" keys.
C
D
MODE
STORE MANUAL
FOOT
LEFT C:
PHOTO
FOOT
RIGHT D:
PHOTO
HAND
GRIP:
LIGHT
Configuration
mode 1