Operation Manual

46 SB1000-001_v01
Dear Customer!
Congratulations on your choice of our appliance, and
welcome among the users of Zelmer products.
Please read this instruction manual carefully. Pay special
attention to important safety instructions. Keep this instruction
manual for future reference.
Safety operation instructions
Make sure that the following guidelines have been
understood.
Before using the device, read the whole content of the
manual.
or instruction concerning use of the appliance by
a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Caution!
Not observance can result in damage to
possessions
Connect the appliance to 220-240 V mains supply.
Do not unplug by pulling on cord.
The supplying cord shall not be hanged over the edge
of the table or board, nor touch any hot surface.
Do not ll the jug in with boiling liquids.
Keep the stand blender and supplying cord away from
hot surfaces and burners.
If it is possible, store the stand blender away from
direct sun radiation and glow-like light.
Never store the blender with the lid on the jug. Moisten
the lid sealing ring with water, and place the lid on the
blender jug before use.
Do not ll the jug over 1500 ml mark – in such case, the
content of the jug can lift the lid when the motor starts up.
Do not overow the jug. In case the liquid gets under
the motor housing, it can be vacuumed into the motor,
causing its damage.
After 2 minutes of work stop operation of appliance for
at least 1 minute, allowing the engine to cool down.
The process of mixing can have a maximum of ten
two-minute work cycles.
Do not operate when the jug is empty, as it can get
overheated.
The temperature of mixed ingredients should not
exceed 60°C.
Suggestion
Information on the product and suggestions
for its use
The stand blender is intended for domestic usage only.
In case it is used for gastronomic business purposes,
warranty terms and conditions change.
During rst start-up the appliances can emit some
odours. It is a normal phenomenon, which should be
over after a time.
Danger! / Warning!
Health hazard
Always place the appliance on at, plain surface.
Always unplug the appliance when it is not in use and
before cleaning.
Do not operate the appliance if the cord, the housing or
the handle is visibly damaged. In such a case, return
the appliance to a service center.
If the non-detachable part of the cord is damaged,
it should be replaced by the producer or at a proper
service point or by a qualied person in order to avoid
any hazards.
The appliance should be repaired by trained staff only.
Improper repair can result in serious hazard for a user.
In case of defects we recommend you to contact
qualied service desk.
Do not immerse motor housing in water or any other
liquid; do not use it in bathroom and outdoors.
Switch the appliance off, pressing the „
” button
before removing the lid from the jug or the jug from the
motor unit. Wait until blades have come to a complete
standstill.
Switch the appliance off, and unplug it from the mains
before assembling or disassembling accessories or
touching parts that move during operation.
Do not use stand blender without feeder opening
stopper.
Do not put your hands inside the jug, even if it is
removed for cleaning, as the cutting blades are still
dangerous – very sharp.
Do not put any objects (spoon, etc.) into the jug, when
the blender is connected to power supply.
Do not wash the cutting blades directly with hand.
Use the soft brush for washing metal parts, especially
the sharp blades.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
EN