Z-E2026 DEVICE INSTALLATION MANUAL EN
COMPATIBILITY LIST Model Model Version Model Year Model Model Version Model Year VW Polo 6R VW Amorak 2H 2010 – 2014 from 2010 VW EOS 1F from 2006 VW Caddy 2K/2C 2003 – 2015 VW Scirocco III 13 from 2008 VW Caddy SA from 2015 VW Beetle Coupé 5C from 2011 VW T5 7E/7J 2010 – 2015 VW Beetle Cabrio 5C from 2012 VW T6 SG/SF from 2015 VW Golf V 1K 2003 – 2008 SEAT Leon 1P 2005 – 2012 VW Golf V Variant 1K 2007 – 2009 SEAT Toledo 5P 2004 – 2009 VW Golf VI 5K 2008 – 201
CAUTION ● The installation of the ZENEC system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incorrect installation can cause damage to the vehicle and the ZENEC system. ● Correct functioning can only be guaranteed when you use the ZENEC original accessories included in the kit or those optionally available. The ZENEC system and the original accessories must under no circumstances be modified or altered in any way.
EXAMPLE OF INSTALLATION GOLF VI REMOVAL WORK AND PREPARATION: NOTE 1. Remove the ignition key and keep it outside the car until the installation is finished. 2. Please wait for ca. 10 minutes until the CAN bus system is completely shut down, before you start with the deinstallation of the original device. 3. Now you can start with the deinstallation of the original device. 4. Please switch on the ignition only, when all work steps are done and the ZENEC system is completely mounted. 1 2 1.
INSTALLATION: 5. (No picture) Fit the GPS antenna (No. 3) at a suitable place, and make sure that the GPS reception is not adversely affected due to shadowing by metallic vehicle parts (thermal glazing etc.). Next run the connecting cable to the radio slot. 6. (No picture) If you wish to use it, now fit the external Bluetooth microphone (No. 4) supplied, and run the connecting cable to the radio slot.
10. Connect all the cables to the ZENEC system (No. 1): those previously run in the radio slot, and the original antenna cables. 10 11. Neatly arrange the wires to the side, making room for the ZENEC system. Carefully slide it into the radio slot and fix it in place, using the four original Torx screws. 11 12. Press the trim frame back on to make the installation complete. 12 NOTE ● Make sure that all connectors at the rear of the ZENEC system have sufficient room and are not bent.
CONNECTION DIAGRAM GPS A DAB (see note on DAB antenna page 2) Z-E2026 NAVICEIVER 16 PIN CONNECTOR (DEVICE BACKSIDE) AM/FM A1 A3 A5 A7 A9 A11 A13 A15 D C Q II Q III A1 KL 31 / Power GND B12 C15 B15 C16 A2 KL 30 / Constant +12V PWR A3 KL 15 / Switched +12V PWR A4 A5 Switched +12V amplifier PWR* A6 A7 A8 Reverse *300mA max current E A2 A4 A6 A8 A10 A12 A14 A16 A9 A10 A11 A12 A13 A14 A15 A16 Speaker Rear Right (+) Speaker Front Right (+) Speaker Rear Right (-) Speaker Front Right (-) Speaker Rear
