User manual

ZE-MC294

DEVICE CONNECTIONS

NOTES OF CONNECTION

■ This unit is designed to be used in a vehicle with a 12-volt battery and negative

grounding. Before installing this unit to a mobile home, a bus, or a truck, make sure the

battery voltage is appropriate for this unit to be used, otherwise, install a transformer to

convert the output voltage to 12 V DC.

■ To avoid short circuits in the electrical system, ensure that the negative battery cable is

disconnected before installation.

■ To prevent short circuiting in the wiring which could lead to damage of this unit, secure

all wirings with cable ties and/or adhesive tape. Route the wirings in a secure manner,

stay away from hot or moving parts such as exhaust pipes, gear shift, handbrake, and

seat rails to prevent the wiring insulation being melted/wore off.

■ Never pass the yellow power cord through the installation hole into the engine

compartment and never ever connect it directly to the car battery. If that happens, it will

most likely produce some serious short-circuits which may permanently damage vital

parts of the electrical system.

■ Replacing a new fuse with 10 A rating when the old one is broken, using no fuse or

fuse with improper rating may cause damage to this unit or even  re. lf a proper fuse is

installed and electrical problems still occur, please contact your local ZENEC dealer.

■ DO NOT connect other equipment to the car battery to avoid battery overheating.

■ Please make sure all the wiring connections and the cables of the speakers are well-

insulated. Otherwise, this unit may be damaged by short circuits.

■

lf there is no ACC available, please connect ACC lead to the power supply with a switch.

■ lf an external power ampli er is connected, please don't connect P.CONT lead to the

power lead of the external power ampli er, otherwise, electric sparks or some other

damage may be the result.

■ Never ground the speaker outputs to prevent damage to the built-in power ampli er.

■ The minimum rating of the speakers connected to this unit is 40 W with 4 to 8 

impedance.

OPTION: CONNECTION TO THE ORIGINALLY EQUIPPED STEERING WHEEL REMOTE

CAN is the abbreviation for Controller Area Network. It is an vehicle speci c Standard-Bus-

Protocol of the car industry. Due to that protocol, the functions of the steering wheel built-

in remote, as well as other vehicle functions, can be accessed and used. Simply connect

the CAN-BUS box option according to the included wiring-diagram. However, we cannot

guarantee that each and every used function will work, as a lot of vehicle use a lot of different

functions for their remote keys.