User manual

ZE-MC294
9
BASIC OPERATIONS
PASSWORD
If you power-on the unit for the  rst time you
need to enter a password. You will also need
to re-enter it every time the unit has been
disconnected from the power supply or when
the battery has been removed or replaced.
Type "012345" (default), using the numeric
on-screen display. Touch
to erase
previous number. Touch
to con rm.
TURN ON/OFF THE POWER
1. Press the (
) button to switch on the unit.
■ The unit resumes with the status it had
before it was powered off.
2. When on, press the (
) button at least
two seconds to switch off the unit.
MUTE
Press the PWR button (
) very brie y to
toggle the sound off and on.
 NOTES:
■ MUTE will be displayed on-screen during
muting.
■ Muting will be cancelled, if you adjust the
volume.
ADJUST THE VOLUME
Rotate the VOL knob to increase or decrease
the volume level.
The adjustable range is 0 to 39.
PLAYING SOURCE SELECTION
Method 1:
■ Press SRC button on the panel or remote
control to cycle through all the available
sources.
Method 2:
■ Open the 'Main menu' by keeping SRC
pressed at the top left corner of the TFT
or press MODE button on remote control,
and then touch the desired option or
select the option by moving the cursor
and then con rm. Touch / on the TFT
to show other options of the main menu.
 NOTES:
■ Devices which are not ready or not
connected cannot be chosen and the
icons will be grayed out.
■ When entering DVD mode allow the DVD
reader up to an entire minute to initialise.
It will auto-enter the DVD-menu if a DVD
is inserted.
PARKING BRAKE DETECTOR
1. The 'PRK SW' cable is connected to the
hand brake switch in order to blank the
DVD screen when the handbrake is not
engaged.
2. If you try to watch a video with the
handbrake released you will see
""WARNING!" Engage Parking Brake to
View Video" on-screen. No video will be
shown on the console screen. Optional
headrest monitors for the backseat
passengers will, however, function
normally.
WHEN REVERSE DRIVING
If the rear view video camera is connected,
the unit automatically switches to CAMERA
source during reverse driving. The unit
returns to it´s previous work after the reverse
driving is done.